A presenter walks on stage.
The projector hangs across the auditorium.
The AV rack sits in a locked control room on the other side of the building.
At short distances, DisplayPort to HDMI is easy. At long distances, things start falling apart:
- signal drops
- flickering
- unstable 4K/8K playback
- extender boxes everywhere
That is usually where fiber becomes the cleaner solution.
The Pacroban DisplayPort to HDMI over MPO Fiber System converts the signal once at the source, then sends it through fiber as light instead of electricity. No mid-run extenders. No repeaters hidden above ceilings.
You get:
- 8K@60Hz
- 4K@144Hz
- HDMI 2.1 output
- up to 300m / 984ft runs
- detachable TX/RX MPO design for easier conduit pulls
This setup makes the most sense in:
- auditoriums
- churches
- universities
- conference halls
- centralized AV rack systems
Visual Placement Suggestions
- Auditorium installation diagram
- “DisplayPort Source → Fiber → HDMI Display” signal flow graphic
- Conduit pull illustration showing detachable MPO connectors
For complete product details and specifications, visit:
Pacroban DisplayPort to HDMI over MPO Fiber System